![]() ![]() The EdgeRouter by default is on a 192.168.1.x network. Out of the box the EdgeRouter X does not have DHCP enabled and the default management port is eth0 therefore, for the initial router setup this involves directly connecting a PC to the router with a network cable into eth0 and configuring the PC to be on the same default subnet as the EdgeRouter. Please note that the final setup may look different depending on what equipment is currently in place and how many devices will be used on the network. Initial setupīelow is a diagram outlining the final desired and recommended setup with the Ubiquiti EdgeRouter X. It is recommended to have the latest firmware running on the router for security and performance reasons. Support does not provide assistance with updating the firmware however, this can be easily done by following the instructions on the Ubiquiti website here. The Ubiquiti EdgeRouter does not auto update its firmware and has to be done manually. Please refer to the Router/Gateway Requirements article for general information about the required parameters.These routers do not have a built-in wireless access point therefore, if wireless access is needed we recommend pairing the EdgeRouter with the Ubiquiti Unifi wireless access point. Read the Knowledge Base article on Ubiquiti Unifi wireless access point for more information. ![]() DNS servers can be changed to improve DNS resolution efficiency to prevent registration issues with Polycom devices.More information about SIP ALG can be found in this article. SIP ALG is enabled by default but can be disabled to prevent issues with phone registration, call/fax failures, and other VoIP-related issues. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |